Making Folding Patio Doors

Author: admin | Categories: Furniture Sets comments
The Folding Patio Doors

Folding patio doors-Measure the width and height of the door. Buy two utility door that is half the width of it. An opening of 71.12 cm require two panels of 35.56 cm. The door panels should be 2.54 to 5.08 cm shorter than under it, if you try to place a rail system. Cut both panels at the same height as necessary to reduce the height of the door. You can crop the hollow core doors 2.54 cm above and below if necessary. Cut it slowly as the outside of the hollow laminate door panel tends to splinter.

Trim the width of each panel 0.32 cm to accommodate hinges. If the folding patio doors are wider than the opening cut 2.54 cm on each side further, if necessary. If you use your folding door blinds, cut both sides of each panel, halfway to maintain a balanced appearance. Sand the cut gently and exposed edges with sandpaper.

Board two panels or shutters, with three piano hinges. Place the panels in the floor, align them by the edges and secure with clamps to prevent movement while installing the hinges. Place the folding patio doors in the final position and check whether the space is appropriate and if the hinges are folded in the right direction.

READ :  Fresh Ideas Bamboo Roll Up Blinds

Comments are closed.